Sim Racing Differential Settings for Cleaner Corner Exits
The car turns in nicely, then the moment you touch the throttle it either pushes wide or the inside rear lights up and you lose a tenth before the next straight.

The car turns in nicely, then the moment you touch the throttle it either pushes wide or the inside rear lights up and you lose a tenth before the next straight. Most drivers blame their right foot, and sometimes they are right, but often the culprit is buried in the setup screen. Sim racing differential settings decide how the two driven wheels share power, and a few clicks there can change a corner exit more than any wing angle.
This guide covers what the differential actually does, what preload, power and coast mean in the major sims, and a simple test routine to find settings that suit your driving rather than someone else's.
What the differential does in a race car
In a corner, the outside wheel travels further than the inside wheel, so it needs to spin faster. An open differential allows that freely, but it also sends power to the wheel with the least grip. On a light, unloaded inside rear, that means wheelspin and wasted torque.
Most race cars use a limited slip differential, usually a clutch pack type. It lets the wheels turn at different speeds up to a point, then locks them together to share torque. How much and when it locks is what you adjust in the setup.
- More locking makes the rear axle behave like a solid bar. It gives strong straight line traction and stability but resists rotation.
- Less locking lets the car rotate more freely in slow corners but allows inside wheelspin and can feel nervous.
Preload, power and coast explained
Sims expose the differential through three main settings, though not every car has all of them.
| Setting | What it controls | Phase of the corner |
|---|---|---|
| Preload | A baseline locking torque, in Nm, that is always present | Whole corner, strongest effect at low speed and mid corner |
| Power (acceleration) lock | How hard the diff locks when you are on the throttle | Corner exit |
| Coast (deceleration) lock | How hard the diff locks when you are off the throttle | Braking and turn in |
Different titles present these in different ways. In Assetto Corsa Competizione, GT3 and GT4 cars only let you change preload, and many baseline setups sit somewhere between 60 and 120 Nm. In the original Assetto Corsa and in rFactor 2 based sims, you will often see power and coast as percentages or as ramp angles. With ramp angles, a lower angle means more locking, which catches many people out. In iRacing, several cars expose preload plus the number of clutch friction faces, where more faces also means more locking.
How each setting feels from the seat
Raise preload and the car feels calmer on entry and more planted on exit, but it will be harder to rotate in hairpins. Raise power lock and you will put power down earlier on a straight exit, but the car may push wide if you get on the throttle while still turning. Raise coast lock and braking becomes more stable, at the cost of some turn in bite. Lowering each one does the reverse.
A test routine that finds your numbers
Diff changes are subtle, and a bad testing method hides them. Use the same routine every time.
- Pick one track and one car. Choose a circuit with at least one slow hairpin and one fast sweeper, such as Brands Hatch Indy or Suzuka.
- Fix everything else. Same fuel load, same tyre pressures, same track temperature, same traction control level.
- Run a baseline. Five clean laps on the default setup, noting average lap time and how the car feels in the two key corners.
- Change one setting by two to three clicks. For preload, try steps of about 20 Nm. For power or coast, try steps of 10 percent or one ramp step.
- Run five more laps. Compare the average, not the single best lap.
- Go further or go back. If the feel improved and the average dropped, try another step in the same direction. If not, return and try the other direction.
Telemetry makes this far faster. Overlay the rear wheel speeds on corner exit. If the inside rear spins visibly faster than the outside, you have room for more power lock or preload. If both rears are equal but the front washes out on throttle, the diff is locking too hard for that corner. The basics of reading those traces are in our guide to sim racing telemetry for beginners.
Why copying a fast driver's diff often backfires
The common advice is to download a setup from a top league driver and use it as is. For most of the setup, that is a reasonable start. For the differential, I think it is usually a mistake.
Differential settings are tightly linked to driving style. A driver who trail brakes deep into the apex can run low coast locking because they keep weight on the front and control rotation with the brake. A driver who brakes in a straight line and then turns will find the same setting makes the rear twitchy on turn in. Power locking works the same way: a fast driver who waits a fraction longer and then goes to full throttle in one motion likes a different diff from someone who feeds the throttle in gradually.
Use a fast setup for springs, dampers and aero if you like, then reset the diff to the car's default and tune it yourself with the routine above. It takes about an hour and usually gives a car you can drive consistently, which matters more over a 45 minute race than a quicker but scarier single lap.
Sim racing differential settings for common symptoms
- Snap oversteer on turn in while braking: add coast lock or a little preload.
- Car will not rotate in slow hairpins: reduce preload by 20 Nm, then re-test.
- Inside rear wheelspin on exit: add power lock or preload. If you are also spinning on corner exit, check throttle application before touching the diff.
- Understeer on throttle mid corner: reduce power lock, or straighten the wheel earlier before full throttle.
- Traction control cutting in constantly: fix the diff first, then reconsider your traction control settings, since TC can mask a diff that is too open.
Frequently asked questions
What does diff preload do in sim racing?
Preload sets a baseline amount of locking that is always active, measured in Nm. Higher preload makes the car more stable and improves traction but reduces rotation, especially in slow corners. Lower preload helps the car turn but can allow inside wheelspin.
Should power lock be higher than coast lock?
In most race car setups power lock is higher than coast lock, because you want traction on exit and freedom to rotate on entry. That is a starting point, not a rule. Drivers who need more braking stability often raise coast lock closer to the power value.
Does the differential matter for front wheel drive cars?
Yes, though it feels different. On a front wheel drive car, more locking improves traction out of slow corners but adds torque steer and understeer on throttle. Many touring cars in sims run a relatively high locking value and rely on the driver to manage the steering.
More in Sim Racing
Sim Racing
Sim Racing Damper Settings and What Each Click Does
The damper page is where setup confidence goes to die.
Sim Racing
Sim Racing FOV Settings and the Numbers That Work
A team mate of mine spent two seasons braking roughly fifteen metres early into the Dunlop chicane and could not work out why.
Sim Racing
Sim Racing Tyre Pressures and the Numbers That Matter
You download a setup from a league mate who is half a second quicker, put in three laps, and the car is wonderful.