Sim Racing Handbrake Guide and Whether Rally Fans Need One
You are halfway through a tight hairpin in a rally stage, fumbling for the button on your wheel that pulls the handbrake, and the car slides wide into a tree. Every rally player hits this moment.

You are halfway through a tight hairpin in a rally stage, fumbling for the button on your wheel that pulls the handbrake, and the car slides wide into a tree. Every rally player hits this moment. A sim racing handbrake puts that control on a real lever by your left knee or right hand, and for the right player it transforms how stages feel. For others it ends up gathering dust, so it is worth knowing which camp you are in before you spend the money.
I drive rally titles most nights and have mounted four different handbrakes on two rigs. Here is what they do, what to look for, and when I would tell you to skip one.
What a sim racing handbrake actually does
A handbrake is a separate lever that sends an analog axis to your PC or console, exactly like a pedal. In a rally game, pulling it locks the rear wheels so the back of the car rotates around the front. You use it for hairpins, tight junctions and the occasional rescue when the car is pointing the wrong way.
The key word is analog. A button on the wheel is on or off. A proper handbrake lets you pull 20 percent for a small correction or yank it fully for a hairpin. That range is what makes the car feel controllable rather than twitchy.
The games where it matters most:
- Rally titles such as EA Sports WRC, Dirt Rally 2.0 and Richard Burns Rally with its community mods.
- Drift setups in Assetto Corsa, where the handbrake starts and extends slides.
- Soft body sandboxes like BeamNG.drive, especially for rallycross and off road maps.
In circuit racing titles, a handbrake does almost nothing useful.
Sensor types and why they matter
Handbrakes use the same sensor families as pedals, and the sensor decides how the lever feels over months of use.
| Sensor | Typical price | Feel | Longevity |
|---|---|---|---|
| Potentiometer | $40 to $80 | Fine when new, can get noisy | Wears with use, may spike after a year or two |
| Hall effect | $70 to $200 | Smooth, position based | Contactless, very long life |
| Load cell | $150 to $350 | Pressure based, like a real lever under tension | Excellent, needs firm mounting |
For most players a hall effect unit is the sweet spot. It does not wear out, it is accurate enough for any rally game, and it costs a fraction of a load cell. If you already know you prefer pressure based control from your brake pedal, the logic in our piece on load cell brake pedals applies here too, though the benefit is smaller because you rarely modulate a handbrake for long.
USB or through the pedal base
Many handbrakes connect directly by USB and appear as a separate device. That works on PC with any game that allows custom binding. On console, a standalone USB handbrake usually will not work at all; you need a unit that plugs into your wheel base or pedal set through the manufacturer's own port. Check this before you buy. It is the most common reason handbrakes get returned.
Mounting a handbrake so it stays put
A handbrake takes sharp, heavy pulls. If it is mounted badly, the whole rig flexes and the lever loses its precision. Three things matter:
- Position. Put it beside your seat at roughly the height of your hand when your arm hangs relaxed. Most rally cars put the lever to the right of the driver, next to the gear stick, so that side feels natural for most players.
- Angle. Vertical mounting suits rally, where you pull up and back. Tilting it 10 to 20 degrees towards you makes long sessions easier on the wrist.
- Rigidity. Bolt it to an aluminium profile rig or a dedicated shifter plate. Desk clamps work for light units but tend to creep on a load cell.
If you already run a sequential shifter, a combined mount that holds both side by side saves space and keeps your hand movements short. Our sim racing shifter guide covers the mounting plates that fit both.
Setting it up in game
Once it is mounted, bind the handbrake as an axis, not a button. Then set a small deadzone at the start of the travel, around 3 to 5 percent, so resting your hand on the lever does not drag the rear wheels. In most rally games the default response curve is linear, and I would leave it that way for your first week.
Calibrate after mounting, not before, because tightening the bolts can change the resting position slightly. Then drive a short tarmac stage with tight hairpins and practise a three step routine: brake to load the front, turn in, pull the handbrake briefly to rotate, then release and power out. Ten runs of a single stage will tell you more than an hour of free roam.
The advice I disagree with: every rig needs one
You will see setup guides that list a handbrake as essential gear, right after a wheel and pedals. I do not agree. For a large share of sim racers it is the wrong place to spend money.
If you mainly drive GT, touring car or open wheel series, you will never touch it. Even in modern rally games, many stages can be driven fast using weight transfer and left foot braking, and a lot of quick players use the handbrake only on a handful of corners per stage. Spending $150 on a lever you use eight times in ten minutes makes less sense than putting that money towards better pedals or a sturdier seat.
My rule: buy a handbrake once you drive rally or drift at least a third of your sim time, or once you catch yourself missing hairpins because the wheel button is awkward. Before that point, upgrades that affect every corner of every lap pay back faster. If your seat still shifts when you brake hard, for example, sort that first with our guide to choosing a sim racing seat without rebuilding your room.
Frequently asked questions
Do you need a handbrake for sim rally?
No, but it helps. You can drive rally games quickly with weight transfer and a wheel button for hairpins. A proper analog handbrake gives finer control and makes tight stages more enjoyable, so it is worth it once rally becomes a regular part of your driving.
Can I use a sim racing handbrake on console?
Only some models work on console. Standalone USB handbrakes are usually PC only. For PlayStation or Xbox, choose a handbrake that connects through your wheel base or pedal set and check that the manufacturer lists your console.
Is a hall effect or load cell handbrake better?
A hall effect handbrake is the better value for most players because it is accurate and does not wear. A load cell feels more like a real lever under tension, but it costs more and needs very rigid mounting to shine.
More in Racing Gear
Racing Gear
Sim Racing Aluminium Profile Rig or Folding Cockpit
My first wheel lived clamped to a particleboard desk.
Racing Gear
Bass Shakers for Sim Racing and How to Fit Them Cheaply
I spent two seasons locking the fronts into the first corner at Monza without knowing it until I watched the telemetry...
Racing Gear
Sim Racing Wheel Stand or Desk Clamp and Which One to Buy
Your wheel slides across the desk under heavy force feedback, the pedals creep forward every time you stamp on the brake, and...